Simple Guide on DSC Alarm System

In this article, we will be providing a simple guide on how to operate DSC 1832 Alarm System installed at your premises. The guide teaches user on how to Arm/Disarm the system and it’s basic features.
 
Arming the System
 
-       Ensure you are the last person to leave the premises before Arming your system.
-       If the Green Ready light is ON, the system is ready for arming. If the Ready light is OFF, check to see that all doors and windows are closed and that motion is stopped in areas covered by motion detectors.
-       Enter your access code. As each digit is entered, the keypad sounder will beep. If the access code was entered incorrectly, the keypad will sound steadily for one second. If this occurs, press the [ # ] key and re-enter your access code. Exit the premises through the door indicated by the installer as the Exit/Entry door.
-       The panel will provide an exit delay period, indicated by keypad beeps, for you to exit the premises without causing an alarm.

Disarming the System
 

• Enter the premises through a designated Exit/Entry door; entering by any other door will sound an immediate alarm. As soon as the Exit/Entry door is opened, the keypad will beep to indicate that the system should be disarmed.
• Go to the keypad and enter your access code. If an error is made entering the code, press [ # ] key, re-enter your code correctly. As soon as the correct code is entered, the armed light will goes off and the keypad will stop beeping.

 
Basic Feature:
 

1. Press * 1: - To Bypass zone
2. Press * 2: - To view trouble (Refer to page 2)
3. Press * 3: - To view alarm memory
4. Press * 4: - Chime On / Off
5. Press * 5: - Change / Add / Delete code
6. Press * 6: - User’s programming
7. Press * 8: - To installer programming mode

 
(A) To Change Master Code: -
      1) * 5
      2) Enter 1234 (Default Master Code)
      3) Key-in 40
      4) Enter new 4-digit master code
      5) # to exit.
 
(B) To Change User Code: -
      1) * 5
      2) Enter master code
      3) 01 (for user 1), 02 (for user 2)……. 40 (maximum 40 users)
      4) Enter 4 digit user codes
      5) # to exit.
 
(C) To Delete User Code or Overwrite the Old Code: 
      1) * 5
      2) Enter master code
      3) 03 (for user 3)
      4) Press * key follow by #. (Or key-in the new to replace the old code)

If you require further assistance, feel free to drop us a mail at sales@vin-services.com or call us at +65 8727 7634. We will be pleased to offer our help.